Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: Why So Many Steps to Start (Restart) Flex 6600M After Upgrade?
Al, In the “select a version” screen, tap the little gear in the lower left. Then enable “auto connect.”2 -
Re: v3.2 Venting
I see that snap to tune is permanently enabled but I do not understand why 1Hz tuning is not possible. With a slice receiver’s step button set to 1, the tuning dial seems to operate in 1Hz steps.1 -
Re: v3.2 Venting
For the sole purpose of noting that experiences vary, updating my 6600M was easy, rapid and problem-free.1 -
Re: SmartSDR and New Radio
Meaning both your computer and your radio are each individually connected to your router?1 -
Re: Flex 6400
Yes, a hand microphone. Many who are particular about transmitted audio replace it with a better unit.1
